Auto parts moulds hot runner system accounted for a large parts in hot runner industry.

More and more plastic injection mould manufacturer are opting hot runner system.

In the choice of auto parts mould hot runner supplier,we require hot runner manufacturer specialization degree is higher and higher.

Auto parts are divided into interior and exterior parts.

In general,interior parts surface requirement is not very high.

But for assemble requirement is very high. We generally use open hot runner system to inject these parts.

Smaller products is use pin point gate nozzle and the lager parts is use direct gate nozzle.

Some auto parts also can use cold runner system. Most high-end car is use hot runner system to inject and molding.

So ,a large part of auto mould supplier have no idea in how to choose auto parts moulds hot runner system.

Some auto appearance parts weld required is very high,such as bumpers, door plank, grille, instrument desk etc.

Of course some auto interior fittings requirement for weld mark also high.

These important position is not allow appear weld line.

In this case,we should use valve gate hot runner system to adjust weld line place.

Some auto appearance parts do some leather process to lower welded line influence.

Syventive is doing a good job in auto parts moulds hot runner system.

But Syventive price is expensive. Anole hot runner is also in the field in auto parts mould hot runner system.

We keep a very good cooperation with Nissan.